149 A5, Harare, ZimbabweManufactured in India · Supplied to Zimbabwe

Equipment selection

Truck, Tractor or Crawler? Choosing a Borehole Rig Mounting

Mounting is only one part of the decision. Compare the work, the carrier, the compressor and the supply scope before you choose truck, tractor or crawler.

Truck Mounted Drill Rig

Most buyers start by asking which mounting they need: a truck, a tractor or tracks. It is a good question, but it is only one part of the decision. The mounting decides how the rig reaches the drilling point; the drilling assembly, compressor and tooling decide what it can do once it gets there. This guide compares the three mountings and shows how to look at the whole package.

Truck-mounted rigs

A truck rig carries the drilling assembly on a heavy chassis, often with the compressor and rod carrier on the same truck or on a second support truck. It is the usual choice for drilling contractors in Zimbabwe who move between many sites by road.

  • Best for: contractors drilling many boreholes a month at sites with road access.
  • Strengths: fast moves between sites, quick set-up, room for a large compressor.
  • Watch for: soft ground, steep tracks and tight farm gates; chassis condition if buying used.

Tractor-mounted rigs

A tractor rig takes hydraulic power from the tractor PTO and uses the tractor to move. It suits farms and smaller operators who already own a 75 HP to 90 HP tractor and drill a moderate number of holes.

  • Best for: farm boreholes, irrigation and domestic wells, solar piling.
  • Strengths: lower capital cost, good access on farm tracks.
  • Watch for: the compressor runs on a separate skid; depth and diameter are more limited than on a heavy truck rig.

Crawler rigs

A crawler rig moves on tracks. It reaches drilling points on soft, rocky or sloping ground and positions accurately without a prepared road. Between sites it normally travels on a low-bed trailer.

  • Best for: remote water projects, exploration, quarry benches and difficult farms.
  • Strengths: access and stability on rough ground.
  • Watch for: the cost and logistics of a low-bed for long moves.

Side-by-side comparison

QuestionTruckTractorCrawler
Moving between sitesFast by roadSlow on road, good on farm tracksNeeds a low-bed
Access to the drill pointNeeds firm, fairly level groundGood on farmsBest on rough ground
CompressorOn the truck or a support truckSeparate skidSeparate unit or on-board
Typical buyerDrilling contractorFarm or small operatorRemote projects, mining

Compare the whole package

Two offers with the same mounting can be very different machines. Before comparing prices, check each offer for:

  • Rotary head torque and speed range, pull-up and pull-down force
  • Mast travel, which sets the rod length you can handle
  • Compressor air volume and pressure, and whether it is included
  • Rods, hammers, bits and subs: sizes and quantities
  • Training, documents, spares and the delivery point in Zimbabwe

Our quotation checklist walks through each of these. If you are still unsure, describe the job and we will suggest a configuration.

Questions

Which mounting is cheapest?

A tractor rig usually has the lowest purchase price if you already own a suitable tractor, but compare the full package, including compressor and tooling, against the work you plan.

Can a crawler rig drill as deep as a truck rig?

Depth depends on the drilling assembly, pull-up force and compressor rather than the mounting. Crawler and truck rigs can be configured for similar depths.

Keep reading

More buying guides

Start a clearer conversation

Tell us the job. We will configure the rig.

Share the work, the location in Zimbabwe and what you already know. We reply with questions or a written proposal listing exactly what is included.

CallWhatsAppGet a quote